Hardware test

Stick Drift Test

Connect your controller by USB or Bluetooth and press any button. Each stick's dot should sit dead center when you let go. Run the hands-off test to measure how far it wanders: anything past the deadzone most games use is drift you'll notice in play.

Updated · Runs in your browser, nothing is uploaded

No controller found

Connect a controller and press any button.
Browsers only show a controller after a button press.
Still nothing? Close Steam, DS4Windows or similar apps, which can take the controller over, then unplug and reconnect it.

How to read the result

Each stick reports its position from −1 to 1 on two axes. At rest both should read close to 0. The hands-off test records the furthest each stick strays from center over three seconds, without you touching it.

Furthest from center at restWhat it means
Under 0.05No drift. Small offsets like this are normal on every controller.
0.05 to 0.15A slight offset. Almost every game's deadzone hides it.
0.15 to 0.24Early drift. Games with a small deadzone, or with the deadzone turned down, will show slow movement.
Over 0.24Drift. That's past the default deadzone Microsoft recommends for Xbox controllers (7,849 and 8,689 out of 32,767, about 0.24 and 0.27), so most games will move on their own.

For circularity, roll each stick slowly around its outer edge two or three times. A perfect circle averages 0% error. Up to about 10% is typical. Some controllers, including many PlayStation pads, read past 1.0 toward the diagonals by design, which shows as a slightly square outline.

How to fix stick drift

  1. Recalibrate. On PC, use Steam's controller calibration or Windows "Set up USB game controllers". Xbox and PlayStation consoles don't have a calibration menu, but updating the controller firmware sometimes helps.
  2. Clean around the stick. Push the stick to one side and blow compressed air into the gap, all the way round. Dust inside the stick's sensor is a common cause of early drift.
  3. Raise the deadzone in the game or in Steam Input. It doesn't fix the stick, but it hides a small offset.
  4. Use the warranty. Sony, Microsoft and Nintendo all repair or replace drifting controllers in warranty, and some offer repairs after it.
  5. Replace the stick module, or the controller. Controllers with Hall effect or TMR sticks read position with magnets instead of a rubbing contact, so they don't wear into drift the same way.

Questions

Which controllers work?

Any controller your browser recognizes: Xbox, PS5 DualSense, PS4 DualShock 4, Switch Pro and most PC pads, by USB or Bluetooth, in Chrome, Edge, Firefox and Safari. If the page shows a controller but the buttons are in odd places, the browser doesn't know its layout; the sticks still read correctly.

Can I test Joy-Cons?

Each Joy-Con connects as a separate controller with one stick, so pick it in the list and use the left stick view. Results depend on the browser, and Chrome handles them best.

Why does vibration not work?

Browsers only support rumble on some controllers and connections, mostly Xbox and PlayStation pads in Chrome and Edge. If nothing happens, it doesn't mean the motors are broken.

Does the browser apply its own deadzone?

No. The values here are what the controller reports, before any game or Steam Input deadzone. The circle you set with the deadzone slider only shows where a game's cutoff would be.