Hardware test

Mouse Test

Point at the test area, then press every button and roll the wheel both ways. Each input lights up on the mouse and adds to its counter. A button that never lights up isn't reaching your computer, and a wheel that logs the wrong direction has a worn encoder.

Updated · Runs in your browser, nothing is uploaded

Test area

Point here, then click, roll and tilt

  • Left click0
  • Right click0
  • Middle (wheel) click0
  • Back side button0
  • Forward side button0
  • Wheel up0
  • Wheel down0
  • Tilt / scroll left0
  • Tilt / scroll right0

How to test your mouse

  1. Move the pointer into the test area. The page stops scrolling and right-click menus there, so every input is caught.
  2. Press each button a few times: left, right, the wheel click, and the two side buttons if your mouse has them.
  3. Roll the wheel slowly up, then slowly down. On a mouse with a tilting wheel or a side wheel, push it left and right too.
  4. Read the counters and the log. Each press shows as a down and an up line with how long you held it.

Reading the results

What you seeWhat it usually means
A button never lights upThe press isn't reaching the computer. Check that the mouse software hasn't remapped or disabled it, then try another USB port or a fresh battery. If it still fails, the switch is dead.
A click lights up twice for one pressSwitch chatter, the most common way mouse buttons wear out. Run the double click test to confirm it.
Wheel up sometimes logs as wheel downThe wheel encoder is worn or dirty. Blowing compressed air into the wheel gap can help for a while.
Each wheel notch logs as several stepsNormal on mice with a free-spinning or high-resolution wheel. On a notched wheel it points to a setting in the mouse software.
A side button lights up as Back but the other does nothingUsually remapped in the vendor software (to a DPI shift, a macro or a keyboard key). Reset the profile and test again.

Questions

Why did my browser go back when I pressed a side button?

Browsers treat the side buttons as Back and Forward. Inside the test area we cancel that, and in most browsers it works. If the page still goes back, the button works: come back and keep testing with the pointer inside the area.

Can I test a laptop touchpad?

Yes. A tap or a press counts as a left click, a two-finger tap as a right click, and two-finger scrolling shows as wheel input. Touchpads send many small scroll steps, so expect high wheel counts.

My mouse has more buttons than this shows.

Web pages only receive the five standard buttons and the wheel. Extra buttons are handled by the mouse's own software, which turns them into keystrokes or macros the browser never sees as mouse buttons.

Does it work on a phone or tablet?

Only with a mouse connected. Touch input isn't a mouse, so the test ignores it.